Move Azure Edge Hardware Center resource across Azure subscriptions and resource groups via the Azure portal

• 
  

This article explains how to move an Azure Edge Hardware Center resource across Azure subscriptions, or to another resource group in the same subscription using the Azure portal.

Both the source group and the target group are locked during the move operation. Write and delete operations are blocked on the resource groups until the move completes. This lock means you can't add, update, or delete resources in the resource groups. It doesn't mean the resources are frozen. The lock can last for a maximum of four hours, but most moves complete in much less time.

Moving a resource only moves it to a new resource group or subscription. It doesn't change the location of the resource.

Prerequisites

Before you begin:

• If moving your resource to a different subscription:

  • Make sure that both the source and destinations subscriptions are active.
  • Make sure that both the source and resource subscriptions exist within the same Microsoft Entra tenant.
  • The destination subscription must be registered to the Microsoft.EdgeOrder resource provider. If not, you receive an error stating that the subscription is not registered for a resource type. You might see this error when moving a resource to a new subscription, but that subscription has never been used with that resource type.

• If moving your resource to a different resource group, make sure that the account moving the resources must have at least the following permissions:

  • Microsoft.Resources/subscriptions/resourceGroups/moveResources/action on the source resource group.
  • Microsoft.Resources/subscriptions/resourceGroups/write on the destination resource group.

Move resource group or subscription

1. In the Azure portal, go to the Azure Edge Hardware Center resource that you want to move. The Azure Edge Hardware Center resource in this example is created for an Azure Stack Edge order.

   • To move to another subscription, select the option available for Resource group (Move).
   • To move to another resource group within the same subscription, select the option available for Subscription ID (Move).

   

2. On the Source + target tab, specify the destination Resource group in the same subscription. The source resource group is automatically set. If you are moving to a new subscription, also specify the subscription. Select Next.

   

3. On the Resources to move tab, Edge Hardware Center service will determine if the resource move is allowed. As the validation begins, the validation status is shown as Pending validation. Wait for the validation to complete.

   

   After the validation is complete and if the service determines that the resource move is allowed, validation status updates to Succeeded.

   

   Select Next.

4. On the Review tab, verify the Selection summary and select the checkbox to acknowledge that tools and scripts will need to be updated when moving to another resource group. To start moving the resources, select Move.

   

5. Check the notification in the Azure portal to verify that the resource move has completed.

   

Verify migration

Follow these steps to verify that the resource was successfully moved to the specified subscription or resource group.

• If you moved across subscriptions, go to the target subscription to see the moved resource. Go to All resources and filter against the target subscription to which you moved your resource.

  

• If you moved to another resource group in the same subscription, go to the target resource group to see the moved resource. Go to All resources and filter against the target resource group to which you moved your resource.